SUCF206 4 Bolts Stainless Steel Flange Bearing with Insert Ball Bearing SUNBEARI

SUCF206 4 Bolts Stainless Steel Flange Bearing with Insert Ball Bearing SUNBEARING Product Name Pillow Block Bearing SUCF206 Structure Pillow block Bearing Bearing Inner Dia. Shape Cylindrical Bore Set Screw Inner Diameter 30 mm Housing material Stainless Steel Outer Diameter 108 mm Set screw M6x1 Width 40.2 mm Hexagonal key size for set screw 12 mm Designation, housing SF206 Recommended tightening torque for set screw 3.9 Nm The Designation, Radial Insert Ball Bearing SUC206 Housing Construction Four-Bolt Square Flange Seal 2F - Standard Seal for Y-bearings Bolt Size M10 A 30.5 mm T min. -20 °C Product weight: 1.33 kg T max. 100 °C Material Stainless Steel Mounting Hole Center-to-Center (e) 18 mm Dynamic Load Rating (Cr) 15.3 kN S 15.9 mm Static Load Rating (Cor) 11.5 kN Mounting Slot Width (S1) 19.05 mm Lubrication Standard Lubrication N 12 mm SUCF206 Bearing Features SUCF206 Flange Bearing Unit 1. Good corrosion resistance: stainless steel bearings are not easy to rust and have strong corrosion resistance. 2. Washable: Stainless steel bearings can be washed off without relubricating to prevent the punishment of rust. 3. Can run in liquid: Due to the materials used, we can run bearings and bearing seats in liquid. 4. Slow depletion speed: AISI 316 stainless steel does not require oil or grease for corrosion protection. Therefore, if the speed and load are low, lubrication is not necessary. 5. Sanitation: Stainless steel is naturally clean and does not corrode. 6. High heat resistance: stainless steel bearings are equipped with high-temperature polymer cages or cages without a complete complement structure, which can operate in a higher temperature range of 180°F to 1000°F. (Requires high-temperature grease) SUCF Flange Bearing Application Pillow block bearings are preferentially suitable for occasions that require simple equipment and parts, such as agricultural machinery, transportation systems, or construction machinery. The pillow block bearing is mainly used to bear the combined radial and axial load based on the radial load. Generally, it is not suitable to bear the axial load alone. The inner ring (with a full set of rollers and retainers) and the outer ring can be installed separately. This kind of bearing does not allow the shaft to be tilted relative to the housing, and additional axial force will be generated when the radial load is used. The size of the axial clearance of the pillow block bearing is very important to the normal operation of the bearing. When the axial clearance is too small, the temperature rise is higher; when the axial clearance is large, the bearing is easy to be damaged. Therefore, special attention should be paid to adjusting the axial clearance of the bearing during installation and operation. If necessary, pre-interference installation can be used to increase the rigidity of the bearing.