SAA certification

Certification introduction: SAA is Australia's standard body for Standards Association of Australian certification, so many friends call it Australian certification. Electrical products entering the Australian market must comply with SAA certification. There are two main types of SAA logo, one is formal approval, the other is standard mark. Formal certification can only be done by samples, and standard marks are subject to factory review. The scope of SAA certification is divided into quality management system, environmental management system, occupational health and safety management, information safety management, and information safety management. See that the application period for Australian SAA certification is 3-4 weeks and may be extended if the product is not up to standard. If the product is uncertified, the product will be detained or forfeited or fined. Product scope: Control Electrical Appliances: controlled Electrical Appliances must obtain a Certificate of approval issued by the Supervisory Authority (certificateofapproval),) and specify the identification (must be marked with the certificate number). It should be noted that the authentication process is only for security and not for performance or quality, except in relation to security. The first letter of the certificate number indicates which state or territory the certificate was issued. For example, Q91610 (Queensland) W2015 (Western Australia West Australia) N10422 (New South Wales New South Wales ) 2. Unregulated electrical appliances: Although non-regulated products are not compulsory to obtain certification, their safety is the responsibility of the seller / manufacturer, and can apply for certification voluntarily. The monitoring department will issue a compliance certificate (CertificateofSuitability). For products that meet the standard requirements Electrical products that have obtained a certificate of conformity may be marked with a certificate number, and the final letter of the certificate indicates the state or territory by which the certificate was issued, For example: CS/431/Q (Queensland) CS/108/N (New South Wales) RCM logo: Regulato is currently being introduced in Australia and New Zealand Ry Compliance Mark), implements a uniform logo for electrical products, a trademark owned by regulators in Australia and New Zealand that says the product meets both safety and EMC requirements and is not mandatory. After obtaining full safety certification and EMC registration, you can apply for the use of the RCM logo. SAIGLOBAL logo: a product safety mark issued by SAI (original SAI) through the regulatory authority that issued the safety certification or "RCM Registrar" (Standards Australia). This sign is Non-mandatory, and requires factory inspection and so on. Certification process: 1. Fill in the application form 2. Product sample test 3. Product rectification (when testing is not up to standard) 4. Issuance of a report 5. Reporting assessment 6. Issuance of certificates Certification materials: 1. 2-4 samples 2. Circuit schematic (please note that the parameters of the device must be consistent with the nameplate and instructions) 3. Layout of printed circuit, location of parts A products with electronic circuits shall be provided B if the electronic switch, dimmer and other electronic components are certified not to provide this 4. English specification (specification must have factory name or trademark, model, parameters, installation method and necessary safety warning) 5. Model difference statement (if there are multiple models in the same series, clearly list the similarities and differences between models. The declaration shall be signed.) 6. Label / nameplate 7. Product installation structure / explosive chart (please specify parts number and parts name.) 8. List of key components (signed) The A format is as follows and the parts are listed in turn according to the codes in the explosion diagram; B fill in one sheet for each series. If a component is suitable for a specific model, please indicate 9. A copy of the certificate of the important components related to security (refer to the requirements of the "list of key parts" to provide the certificate and check the number on the certificate and whether the parameters match the actual sample.) Certification cycle: In general, the period of, IT AV lamps and household appliances applying for Australian SAA certification is 1-2 weeks and 3-4 weeks. If the product quality is not up to standard, the date may be extended.